Instructions for use

Rinse Pimp connection diagram

*Above diagram is for connection information only, the Rinse Pimp must be vertical for optimum results*

Step 3

Connect the Rinse Pimp as shown in the diagram above. The Rinse Pimp should be wall mounted vertically with the flow going down (for wall mounting instructions click here). Keep the length of the hose from the Rinse Pimp to the vehicle as short as possible to avoid wastage. Rinse the vehicle for a second time using the filtered water with the spray gun set to 'Super Mist'.

Step 4.

Leave the vehicle to dry naturally to reveal the effortless spot-free shine.

For best results and to extend the resin life we recommend the following:

• Do not use in conjunction with a pressure washer

• Keep flow rate to a minimum (we recommend about 2 litres per minute)

• Use water from the Rinse Pimp sparingly, only use enough water to re-wet all surfaces

• Mount vertically and feed water from the top each time so that the water travels through the resin in the same direction.

• The resin colour change mechanism is affected by sunlight. After use drain and store in darkness.

• The resin will change colour from blue to orange to signal when replacement is becoming due.

For a pdf printable version of the instructions for use click here to visit our download page

For wall mounting instructions click here

For Rinse Pimp refill instructions click here

If you have a hose pipe ban in your area click here for our hose pipe ban survival guide!

For customer testimonials for the Rinse Pimp please click here